DeWalt DCS372KA Manual De Instrucciones página 14

INTENDED USE
This metal cutting circular saw is intended for use by professionals for
cutting light gauge metals and small metal structural shapes.
DO NOT use under wet conditions or in presence of flammable liquids
or gases.
This metal cutting circular saw is a professional power tool. DO NOT
let children come into contact with the tool. Supervision is required
when inexperienced operators use this tool.
WARNING: Do not plunge cut or pocket cut with this saw.
Windows (Fig. 2)
WARNING: Do not operate the saw with a damaged or
missing sight window. If window is damaged or missing, have
the saw serviced at an authorized service center. If saw is operated
without the window, metal chips could fly through the guard and
cause personal injury.
CAUTION: Do not use oil or cutting fluids with the metal-
cutting saw. Do not use cleaning fluids to clean window.
Cleaning fluids, cutting fluids or oils could harm the plastic in the
window, interfering with the safe operation of the saw.
The saw is equipped with a sight window (J) on the side of the upper
guard. This window allows the user to see a cutting line on the material
to be cut.
Saw Shoe (Fig. 2)
The front of the saw shoe (K) has a kerf indicator (E) that allows the
operator to glide the saw along cutting lines. Aligning the cutting line
with the notch on the front of the shoe and centering it using the
modified V-shaped kerf indicator allows the operator to keep the
blade in line with the cutting line. If the cutting line is visible through
the narrowest part of the kerf indicator, the blade will pass directly over
the cutting line.
OPERATION
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 3)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (I) into the tool handle, align the notch inside
the tool's handle with the battery pack and slide the battery pack firmly
into the handle until you hear the lock snap into place as shown in
Figure 3.
FIG. 3
To remove the battery pack from the tool, press the release buttons (M)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
12
I
M