Publicidad
Idiomas disponibles
Idiomas disponibles
Blade Service (continued)
Installing the Blades
Operating a machine after incorrectly installing the blade assembly and/or not using
genuine Toro blade and blade hardware could allow a blade or blade component to be
thrown out from under the deck, resulting in serious injury or death.
Always install genuine Toro blades and blade hardware according to the instructions.
1. Install the blade as shown.
Note:
pointing upward toward the inside of the
mower to ensure proper cutting.
2. Torque the blade bolt to 81 to 108 N·m (60 to
80 ft-lb).
Leveling the Mower Deck
Ensure that the mower deck is level any time you install the mower deck or when you see an
uneven cut on your lawn.
Preparing to Level the Mower Deck
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3. Ensure that the tires are inflated to the correct specifications and the caster wheels are
facing straight forward.
4. Check the mower deck for bent blades; remove and replace any bent blades.
5. Raise the mower deck to the 76 mm (3 inch) height-of-cut setting.
3466-517A
The curved part of the blade must be
WARNING
G451425
position.
ARK
Page 5–28
Maintenance: Mower-Deck Maintenance
Publicidad
