Troy-Bilt 020241 Manual Del Operario página 12

Section 4: Operation
How to Use Accessory Tray
The unit is equipped with an accessory tray with phces to
store your spray gun and nozzle extension.There is also a
hook at the front of the accessory tray to hold your high
pressure hose.
NOTE:The extra hole in the tray is for storing a utility
brush.The extra dip in the tray is for storing a turbo
nozzle.The brush and turbo nozzle are NOT included with
your pressure washer.You can buy these items as optional
accessories.
[. PHacenozzHe extension through hoHe on accessory tray_
as shown in Figure H2.
2. PHacespray gun through hoHe on accessory tray on
right side of unit (Figure 12).
NOTE:You may also use the hooks attached to the base
and handle to store your gun and nozzle extension, as
shown on page 6.
3. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown in Figure 12.
How to Use Spray
Tips
The quick-connect on the nozzle extension allows you to
switch between four different quick connect spray tips.The
spray tips vary the spray pattern as shown (Figure 13).
[ cAuTlo.
]
Follow these instructions to change spray tips:
[. Engage trigger lock on spray gun.
2. Putt back co[tar on quick-connect and putt current
spray tip off. Store spray tips in slots on holder that's
attached to nozzle extension.
3. Select desired spray tip:
For gentle rinse, select white 40 ° spray tip.
To scour surface, select yellow 15 ° or red 0 ° spray
tip.
To apply chemical select black spray tip.
Low Pressure
Bhck
Use to apply
chemical
H[gb Pressure
40 ° White 15 ° Yellow 0 ° Red
4. Pull back on collar, insert new spray tip and release
collar.Tug on spray tip to make sure it is securely in
place.
5. For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray
tip too dose, you may damage cleaning surface.
6. DO NOT get closer than 6 inches when cleaning tires.
" NEVER exchange spr D, tips without locking the trigger loci<
on the trigger: