Troy-Bilt 020241 Manual Del Operario página 7

ASSEMBLY
mNPORTANT: Read entire operator's manua[ beforeyou
attempt to assembHeor operate your new pressure washer.
Remove Pressure Washer from
H. Remove the parts bag_accessories_ and inserts included
with pressure washer.
2. SHicetwo corners at the end of carton from top to
bottom so the panel can be folded down fiat.
3. Remove pressure washer from carton.
Carton Contents
[terns in the carton include:
Main Unit
Safety GoggHes
Handle
Hastic Accessory Tray
High Pressure Hose
Spray Gun
Nozzle Extension with Quick Connect Fitting
Oil Bottle
Parts Bag (which includes the following):
Operator's Manual
Engine Manual
Emissions Control Warranty Sheet
Owner's Registration Card
Bag containing 4 mulrJ-cdored Quick Connect Spray
Tips
Handle Fastening Hardware Kit (which includes):
Carriage Bolt
%" Bolt (2)
Plastic Knobs (3)
Tree Clips (4)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged_ call the
pressure washer helpline at i -888-6 i i -6708_
To prepare your pressure washer for operation, you
will need to perform these tasks:
I. Fill out and send in registration card.
2. Attach handle to main unit_ then attach accessory tray
to handle.
3. Add oil to engine crankcase.
4. Add fuel to fuel tan[<.
5. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect spray tip to nozzle
extension.
Attach Handle and Accessory Tray
I. Place handle onto handle supports connected to main
unit. Hake sure holes in handle align with holes on
handle supports (Figure I).
Handle
Align
NOTE: [t may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
O