Publicidad
Idiomas disponibles
Idiomas disponibles
Tighten adjust nut
B to raise mower
Loosen adjust nut
B to lower mower
Loosen jam nut A first
NOTE:
Each full turn of the adjustment
nut will change mower height about 1/8".
• Recheck measurements,
adjust if nec-
essary until front tip of blade is 1/8" to
1/2" lower than the rear tip.
• Hold adjustment nut in position with
wrench and tighten jam nut securely
against adjustment nut.
@
TO REPLACE MOWER DRIVE BELT
MOWER
DRIVE
BELT REMOVAL
1.
Park tractor
on a level surface.
Engage
parking
brake.
2.
Lower attachment
lift lever to its lowest
position.
3.
Disengage
belt tension
rod (K) from
ock bracket
(L).
CAUTION:
Belt tension
rod is spring
loaded.
Have a firm grip on rod and re-
lease slowly.
4.
Remove
screws
(P) from mandrel
cov-
ers (Q) and remove
covers.
5.
Remove
any dirt or grass clippings
which
may have accumulated
around
mandrels
and entire
upper deck sur-
face.
6.
Remove
belt from electric
clutch
pulley
(M), both mandrel
pulleys
(R) and all
idler pulleys
(S).
MOWER
DRIVE
BELT INSTALLATION
1.
Install belt around
both mandrel
pulleys
(R) and around
idler pulleys
(S) as
shown.
2.
Install
belt onto electric
clutch
pulley
(M).
IMPORTANT:
Check
belt for proper
rout-
ing in all mower pulley
grooves.
3.
Reassemble
mandrel
covers
(Q). Se-
curely
tighten
all screws.
4.
Engage
belt tension
rod (K) on locking
bracket
(L).
A CAUTION:
Belt tension
rod is spring
loaded.
Have a tight grip on rod and en-
gage slowly.
5.
Raise attachment
lift lever to highest
position.
®
-.@
25
Publicidad
