Olivetti ECR 5600 Guía De Usuario página 12

29 0 = Warning beep will sound at the start of a
transaction in an electronic journal memory
nearly full condition.
1 = Warning beep will NOT sound at the start of a
transaction in an electronic journal memory
nearly full condition.
30 0 = Consecutive counter will not be reset in Z
financial report.
1 = Consecutive counter will be reset in Z financial
report.
97 Print character size value selection:
0 = 7 x 12 Font
1 = 5 x 10 Font — small size
98 Print line space value selection:
0 = 0.5 mm
1 = 0.75 mm
2 = 1.00 mm
3 = 1.25 mm
4 = 1.5 mm
5 = 1.75 mm
6 = 2.00 mm
7 = 2.25 mm
8 = 2.5 mm
9 = 2.75 mm
Changing the Cash Register's Standard Settings
Proceed as follows if you wish to change any of the standard
machine settings indicated in the previous table:
1. Slide the control switch to the PRG position.
2. Type the [number] of the machine condition (1-98 as
indicated in the table) that you wish to alter.
3. Type the [number] of the required setting.
4. Press the [RA/FC] key.
5. Program another feature or exit the program mode by
sliding the control switch to the OFF position.
Example: To save paper when printing your reports and re-
ceipts, select a line space width of 0.5 mm and a font size of
5 x 10.
Type/Press:
[98] + [0] + [RA/FC] + [97] + [1] + [RA/FC]
6
Caption Programming using the Alphanu-
meric Keypad and Character Table
To program customer receipt headers, PLU product names,
department names, clerk names and foreign currency
descriptors you can use just the alphanumeric part of the
keypad to enter non-accented capital letters and the Charac-
ter Table to enter small letters, accented capital and small
letters, special characters or symbols.
Using the Keypad
To use the alphanumeric keypad to enter capital caption
letters, locate the letter wanted and press its associated
alphanumeric key the number of times needed to display it
(the letter will be displayed on the far right-hand side of the
display).
If the same alphanumeric key has to be used for successive
letters of a caption, press the [0] key between the two letters.
Press the [0] key if you also want to add spaces. Any
incorrect letter can be canceled by pressing the [Void/Del]
key that provides the typcal backspace function available in
the PC environment. Confirm your final caption by pressing
the [Check] key.
For example, to write the word BOOKS, press [8] twice, [6]
three times followed by [0], [6] three times again, [5] twice, [1]
four times and then press the [Check] key to confirm your
entry.
Using the Character Table
The Character Table provides all the letters and symbols that
your cash register is capable of printing.
To use this table, first look for the letter or symbol wanted and
then identify its corresponding alphanumeric key listed in the
first column on the left. Press the alphanumeric key on the
keypad the number of times needed to select the character
by reading the number on the row on the top of the table.
Confirm your final caption by pressing the [Check] key.
NOTE: Special accented national letters are not displayed.
For example, to select the letter L, press the [5] key 3 times.
To select the letter Ü, press the [2] key 13 times.
Shown below is your cash register's Character Table.
Character Table