COPYING/ENCODING INSTRUCTIONS
Encoding Vinyl Record (Phono) to USB/SD
1) Set the function button to PHONO mode and then insert a memory device (USB drive,
SD/MMC card).
2) Put your record onto the turntable and get it ready for playback.
3) Press the record
then the USB or SD icon will be flashing on the display.
4) Press the skip up
encoding, then press the record button
a USB drive or an SD/MMC card is inserted.)
5) The system will start the encoding mode after a few seconds.
6) Lower the tone arm to start playback of the record. During encoding, the USB or SD icon will
be flashing on the display.
7) To finish encoding, press the stop button
PHONO mode.
Encoding Cassette to USB/SD
1) Set the function button to TAPE mode and then insert a memory device (USB drive, SD or
MMC card).
2) Press the record button
USB or SD icon will be flashing on the LED display.
3) Press the skip up
encoding, then press the record button
a USB drive or an SD/MMC card is inserted.)
4) The system will start the encoding mode after a few seconds. Insert your cassette into the
playback slot. During encoding, the USB or SD icon will be flashing on the display.
5) To finish encoding, press the stop button
TAPE/AUX mode.
Encoding CD to USB/SD
1) Set the function button to CD/USB/SD mode to play CD and then insert a memory device
(USB drive, SD or MMC card).
2) Press the record
USB or SD icon will be flashing on the LC display.
3) Press the skip up
encoding, then press the record
a USB drive or an SD/MMC card is inserted.)
4) The system will start the encoding mode after a few seconds. During encoding, the USB or SD
icon will be flashing on the display.
REC button. It will take about 3 - 4 seconds to read the memory device,
or skip down
REC, it will take 3 - 4 second to read the memory device, then the
or skip down
REC button, it will take 3 - 4 second to read the memory device, then the
or skip down
REC button again to confirm. (You can skip this step if only
button to select the desired mode (USB or SD) for
REC again to confirm. (You can skip this step if only
. The display will show "END" and return to
button to select the desired mode (USB or SD) for
REC again to confirm. (You can skip this step if only
. The display will show "END" and return to
button to select the desired mode (USB or SD) for
-12-