tbs electronics Omnicharge Solar Serie Manual De Usuario página 18

• Battery state of charge
• Charge current
• Charge power
• Charged Amphours
• Solar charger operating temperature
• Error code
A basic setup covers only the selection of battery type and system voltage. This can be accomplished
as follows. At first the ENTER key has to be pressed for 2 seconds until the battery type indicator
starts flashing. Then short press the ENTER key a number of times until the desired battery type
flashes. Please see the images below:
The following battery types are available:
• USE = User defined / Custom battery type
• FLD = Flooded or open lead acid
• GEL = Gel type lead acid
• SLD = Sealed type lead acid or AGM
• LI
= Lithium type battery (LiFePo4)
Once the desired battery type has been selected and you are sure that the battery- or system
voltage is set correctly too, you can long press ENTER for 2 seconds again to save the setting and
jump back to the normal operating mode. When you need to setup the battery- or system voltage as
well while still operating in the setup mode, please press the SELECT key to switch over to the
voltage selection mode as indicated below:
The current voltage select starts flashing. Please press the ENTER key a number of times until the
desired battery- or system voltage is flashing. You can choose between 12V, 24V, 36V, 48V and
Automatic voltage detection (display shows all available voltages flashing at the same time). Please
note that Automatic detection is not available for Lithium based batteries. When the desired system
voltage is selected, you can long press the ENTER key for 2 seconds again to save the setting and
jump back to the normal operating mode.
The solar charger is now setup correctly for most common systems.
18