Keba e Serie Manual Del Usuario página 15

Using the charging station
Charging station (application example)
Starting the charging procedure
►
The charging cable is neither
plugged into to the vehicle nor
the charging station.
►
Device with standard socket:
Plug the charging cable into
the charging station first.
►
Now plug the charging cable
into the vehicle.
The charging procedure can also be started in reverse plugging sequence.
Ending the charging procedure
The charging procedure is ended by unplugging the charging cable at the vehicle. For details, please
refer to the instructions of the vehicle manufacturer.
Do not use force to pull out a mechanically locked plug!
►
Disconnect the charging cable from the vehicle ("Wait for unplugging").
►
Disconnect the charging cable from the charging station or store the charging cable on the
provided hanger of the device.
Using the charging station
Typical version with charging cable
[A]... Status LED
[B1]... Parking bay for charging plug
[B2]... Standard socket (variants possible)
[C]... Housing cover
[D]... Hanger for charging cable
Storing the charging plug/charging cable
If no charging procedure is being performed,
the charging plug can be plugged into the park-
ing bay [B1] for safe storage.
The charging cable can be coiled up and placed
on the hanger [D].
Note
Depending on the design of the charging sta-
tion, the parking bay may deviate from the form
shown.
Status LED
The charging station must be ready for operation, the status
LED flashes green slowly every 3 seconds ("Ready for opera-
tion").
The status LED lights up orange briefly ("Wait for locking")
while the system attempts to mechanically lock the plug. After
successful locking, the status LED flashes slowly green every 3
seconds again.
The status LED lights up green continuously ("Ready for charg-
ing"). The charging procedure can be started by the vehicle
from this point of time; then the status LED flashes green
("Charging procedure").
15 / 52