Keba e Serie Manual Del Usuario página 18

(*) Possible causes of error for malfunction (status LED flashes red)
Malfunctions must always be acknowledged by unplugging the plug and can be triggered, for ex-
ample, by the following causes:

The plug is not properly inserted; locking is not possible => insert the plug quickly.

The plug was unplugged during the charging procedure:
The plug was not locked correctly – unplug the plug and plug in correctly and make sure it in-
terlocks correctly.

The plug at the charging station sends an invalid state:
Hardware fault of the cable – unplug the plug and plug in correctly, if necessary, replace the
cable.

Temperature shut-off:
The permitted temperature in the charging station was exceeded – unplug the plug and wait
until the charging station has cooled down.
Reset of an error:
If during the inserting of the plug or the charging procedure an interrupt occurs, the charging sta-
tion tries to start the charging procedure again (max. 5 times).
If the charging procedure can't be started, it must be acknowledged by the proper ending of the
charging procedure (see section "Ending the charging procedure") or eventually by rebooting the
charging station. On repeated occurrence of errors without any reason, please contact customer
service.
18 / 52
Troubleshooting