Bosch HMV 5051 U Instrucciones De Instalación página 26

Adapting microwave blower
26
4. Drill ¥" (9,5 mm) holes at "A", "B" and "C"
() CAUTION: Wear safety goggles when drilling holes in the cabinet bottom.
5. Cut out the 2" (50,8 mm) hole at "D". This hole is for the power supply cord.
Note: If the cabinet is metal, use the nyion grommet around the opening to protect
the cord.
This microwave is shipped assembled for Room Venting Installation. The blower
unit is already in place and must not to be adapted.
Proceed on page 27.