Safety Instructions; Storage And Transport; Technical Data; General Information - DMG MixStar-eMotion Instruccion De Uso

DMG MixStar-eMotion
Table of contents
General information
Device and display functions
Getting started
Preparing a cartridge for use
Loading a tray
Filling an elastomer syringe
Exchanging a cartridge
Attaching a mixing tip
Setting the timer
Program presets
Selecting programs
Operation without the timers
Restart
Reset to factory settings
Maintenance and care
Troubleshooting
Packaging
What does the new MixStar offer?
The new DMG MixStar-eMotion is a fully automatic mixing device for
impression materials. To accommodate individual preferences the device
can be operated at 3 different speed levels. All speed levels are electron-
ically controlled and regulated to ensure a consistent speed even with vis-
cous consistencies. To ease the practice routines for dentists and staff two
timers can optionally be programmed for working time and time in mouth
settings. And the recommended time values for each process are speci-
fied on the pre-filled MixStar cartridges. The mixing process is started by
simply pushing the Start button allowing you to guide the tray with both
hands. For a hands-free operation an optional foot switch pedal can be
connected to the unit. The integrated USB interface is used to upgrade
the software.

Safety instructions

13 • Please read these instructions for use carefully.
• Please check before operation that the operating voltage indicated on
14 the rating plate is identical with the voltage available.
• Only use properly grounded sockets to connect the device. If you
14 intend to use an extension cable, make sure the ground line is uninter-
rupted.
14 • Always use MixStar on a flat surface.
• If the unit has been stored below + 10 °C/50 °F please do not operate
15 the MixStar-eMotion has reached room temperature. Otherwise water
from condensation build-up may lead to a short circuit of the unit.
15 • Please use only MixStar compatible products with the MixStar-eMo-
tion. We cannot guarantee proper function with other products.
15
• Use the MixStar-eMotion only for its intended purpose.
• Use only power cords that are approved for use in your country.
15

Storage and transport

15
16 Store and transport the unit between -20 °C to +60 °C (-4 °F to +140 °F)
and a maximum relative humidity of 80 %. For transporting the unit we
16 recommend using the original packaging.
16

Technical data

16
Housing made from high impact resistant resins, hazard class I, type B
16
Dimensions H x W x D
16
Weight
17
Ambient temperture
17
Recommended operating temper-
ature
Time for plungers to return to car-
tridge exchange position from most
forward position
Power supply
Frequency
Fuse [2 x type]
Output
Duty cycle
Pause
USB connector
Foot pedal connector
Foot pedal rated voltage
Foot pedal rated current
English
370 x 180 x 430 mm
(14.5 x 7.08 x 17")
8,9 kg (19.58 lbs)
+5 to +40°C
+18 to +40°C
11 seconds incartridge exchange
position
115 V 30 V
60 Hz 0 Hz
T 4A, 250 V 2A, 250 V
200 W = 200 VA
up to 2 min.
minimum 5 min.
Mini USB B type 5 pin
4 pin type MAS 4100, threaded
24V
0.1A
13