Publicidad
For instructions on how to set up Dante or AES67, see Chapter 7 Dante & AES67, page 14.
Front panel:
(1) PWR
(2) Power indicator
(3) Clip indicator
(4) Mute indicator
(5) MUTE
(6) VOL ↑
(7) VOL ↓
(8) Display
(9) Input channel
dial
(10) XLR channel
indicator
(11) Dante channel
indicator
Back panel:
(12) 48VDC 1A
(13) Dante/ PoE
(ethernet)
input
(14) XLR input
(15) Speaker
output
10
Manual
Power up / down the amplifier in normal mode.
Enter setup mode by pushing for 5 seconds during power-up.
Exit when in setup mode.
Lit when the power is on.
Lit if the amplifier output is overdriven.
If the clip indicator is lit, reduce amplifier volume and make sure the
input volume is not excessive.
Excessive clipping could damage a connected speaker.
Lit when the amplifier is muted.
Press to mute or unmute the amplifier output.
Adjust the output volume by +1dB steps.
Adjust parameters in the setup mode.
Adjust the output volume by -1dB steps.
Adjust parameters in the setup mode.
Displays the output volume in 1 dB steps in the normal mode.
Displays the functions and presets in the setup mode.
Switch between Dante and XLR input channels in the normal mode.
Switch between the filter and power-up parameters in the setup mode.
Lit if the XLR-input is active.
Lit if the Dante input is active.
Input for the provided 48VDC / 0.75A / 36W, center positive, 5.5 / 2.1
mm power adaptor (Use only the provided power adapter)
Input for digital audio, PoE (PD 25,5W) and network features.
Use CAT5e cables or better.
Make sure that the network can deliver sufficient power.
In case of underpowered network delivery or no PoE, use a suitable
PoE injector or an external power supply.
Input for balanced analog audio signal.
Audio output connection for Panphonics electrostatic speakers.
Connect only Panphonics electrostatic speakers equipped with
speakON connectors.
v.1.2/08-23
30.8.2023
Revision 1.2
Publicidad
