Publicidad
Idiomas disponibles
Idiomas disponibles
Reduction insert
Note! Children with a height of up to 60 cm must use a reduction insert (A, fig. 6).
The reduction insert should be removed when the seat is used by a child over 60 cm tall
(B, fig. 6).
Handle adjustment
To change the position of the handle, press the handle adjustment buttons on both sides of
the seat (fig. 7) and adjust the handle to the desired position. There are 4 positions available:
• Car position (1, fig. 7)
• For carrying (2, fig. 7)
• For storage (3, fig. 7)
• For placing the seat on a flat surface (4, fig. 7)
Canopy adjustment
1.
Adjust the canopy to the desired position by pulling the front of the canopy in the
desired direction (fig. 8).
2.
To remove the canopy cover, remove the rubber clips (A, fig. 9), then slide off the
cover (B, fig. 9) and remove the stiffening bar from the attachment points (A, B, fig. 10)
located on the seat.
3.
Remove the stiffening bar from the fabric cover (fig. 11).
BUCKLING A CHILD IN THE SEAT
1.
Place the seat on a level surface.
2.
Loosen the seat belts by pressing the tension adjustment button and pulling on the
belts (fig. 1).
3.
Unbuckle the seat belts by pressing the red button on the buckle (A, fig. 3) and extending
and unbuckling the belt connectors (B, C, fig. 3).
4.
Place the child in the seat.
5.
Adjust the headrest to your child's height (see: Headrest adjustment) (fig. 12). Headrest
adjustment is integrated with belt height adjustment.
6.
Fasten the seat belts (fig. 13). To fasten the seat belts, connect the belt connectors
(A, fig. 4) and then slide them into the buckle (B, fig. 4). You will hear a characteristic
click (C, fig. 4).
7.
To tighten the seat belts, pull the tension adjustment strap in the direction of the arrow
(fig. 2).
‑ 15 ‑
EN
Publicidad
