Lionelo Astrid i-Size Manual De Usuario página 16

Idiomas disponibles

Note! Ensure that the shoulder belts fit properly around the child's shoulders. Proper tension

is ensured if there are two fingers in the space between the shoulder belt and the child's

chest (fig. 14). The belts should be tight against the child's body, but should not be too tight

and cause discomfort.

Note! Make sure that the seat belts fit tightly on the child's body and that they are not twisted.

Make sure the lap belts run low and protect the child's pelvis.

Note! The headrest should be adjusted so that the shoulder straps are not too high, such as

at or above the ear line, nor too low, such as behind the child's back (fig. 15).

UNBUCKLING THE SEAT BELTS

Loosen the seat belts by pressing the tension adjustment button and pulling on the belts (fig.

1). Unbuckle the seat belts by pressing the red button on the buckle (A, fig. 3) and extending

and unbuckling the belt connectors (B, C, fig. 3).

INSTALLATION IN THE CAR

Move the seat handle to the carrying position (A, fig. 16), then place the seat on the

car's seat back in close proximity to the backrest of the rear seat. The seat should be

positioned in the opposite direction to the direction of travel.

Put the car seat belt as far as possible through the green lap belt guides (B, fig. 16) and

fasten the belt (C, fig. 16). You will hear a characteristic click.

Pass a section of the car seat belt under the hinge of the seat holder (D, fig. 16) and

through the green shoulder belt guide, located at the back of the seat (E, fig. 16). Make

sure the belt is tight.

Pull the lap belt horizontally to tighten. Next, pull the shoulder belt to tighten the rest

of the car seat belt (F, fig. 16).

Adjust the car seat handle to the car position (G, fig. 16, see: Handle adjustment).

Note! Make sure the belts are not twisted. Make sure that the belts are correctly positioned

in the guides.

Note! Pay special attention to the position of the car seat belt buckle. Do not position the

car seat too close to the car seat belt buckle. The correct position is indicated by the symbol

√ (fig. 16).

SEAT REMOVAL

Unbuckle the car seat belts and remove them from the belt guides. Move the seat handle to

the carrying position, then remove the seat from the car.

‑ 16 ‑