Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION OF THE SEAT ON THE FRAME OF THE
STROLLER
1.
Insert the adapters into the appropriate place on the frame, following the instruction
manual of the stroller. You will hear a characteristic click.
2.
Insert the seat into the adapters. Make sure the seat is properly locked into the frame
of the stroller. Correct installation will signal a click.
3.
To release the seat from the stroller frame, press the stroller adapter release buttons
(15, fig. A).
COVER REMOVAL
1.
Remove the canopy cover (A, fig. 17, see: Canopy adjustment).
2.
Unbuckle the seat belts (B, fig. 17, see: Seat belt adjustment).
3.
If necessary, remove the reduction insert, (C, fig. 17). Then remove the protective pads
(D, fig. 17) and the seat belt protector (E, fig. 17).
4.
Tilt the lower part of the headrest and slide off the cover (A, fig. 18), then put the
headrest adjustment lever through the corresponding hole (B, fig. 18) and remove the
headrest cover.
5.
Pass the seat belt buckle through the corresponding hole in the cover (A, fig. 19), and
then remove the entire cover by putting the individual hard parts of the seat through
the corresponding holes in the cover (B-E, fig. 19).
6.
To reattach the cover, follow the above steps in reverse order.
CLEANING AND MAINTENANCE
• Clean minor dirt with a damp sponge and a mild detergent.
• The cover can be washed at a maximum temperature of 30°C. For this purpose, the cover
must be completely removed from the seat (see: Cover manual).
• When drying, do not use dryers. The cover should not be exposed to sunlight for drying.
Plastic parts can be cleaned with a damp cloth and mild detergent.
• Note! Do not use strong detergents or bleaching agents.
The photos are for reference only, the actual look of the products may differ from the ones shown in the
pictures.
‑ 17 ‑
EN
Publicidad
