Publicidad
Insert Spacer (BB) on right side. Attach using one screw (CC).
Repeat step 5 to opposite side.
At an angle, insert the three hooks on (D) into (A). Rotate (D) upright to lock
the hooks.
5
Slide Lock Hasp Bracket (I) into channel on lid and push up toward front of (E)
until flush. Fasten with one screw (AA).
6
Repeat steps 3 & 5 to connect ( D) to both B's.
7
o
L
Je)e)e)c)r)oeeeoe)e)oc)e)
ot)c)oe)oeeoc)eoeib)oc)e)oc)
0-00000000000
0006000
000000 ?) 000000'
)
000
0
000eeeeic)e)oe)e)oe
,--
)e)e)
6
)e
,
oe)c)c)eeeeoe)c)oec)oec)e)
oec)eoeoeeeeeeeeL)oc)o
0
-
) - - 7)(si)
,
) eeeeeeeeetooeo
ÉDeeeoeeeeee
--
)oeoc
,
oeof
oeoe
8
Place lid (E) on flat surface. Place (F) in channel on (E). Attach through pre- drilled
holes on each end with two screws (AA). Attach rest from outside toward center
using six screws (AA). There are no pre drilled holes on the lid. Use force when
starting to drive self taping screws. Once the screw pierces the plastic, it will drive
easier.
Note: Two holes on each side of center screw will not be used.
Do not use center hole on ( F).
0
x8
7
Publicidad
