Publicidad
Idiomas disponibles
Idiomas disponibles
13.5
Adjustments before operation
13.5.1 Installing / Replacing Boring Bits
Boring bits are to be installed in the chucks, which
are in turn mounted to the spindles of the machine.
The chucks accept boring bits with 10mm shanks.
Thes boring bits will have a screw inside the shank
(see Fig. 1) . This style of boring bit is a available
from the local tools or woodworking stores.
This machine requires a total of 21 boring bits,
which are standard color coded. There should be 11
right-hand bits (black in color) and 10 left-hand bits
(orange in color).
Always wipe clean the shank of the boring bit before
inserting into the chuck.
CAUTION: When installing or removing sharp drills is careful to handle.
Insert chuck
spindles:
Make sure that the two screws (Fig. 1) are sufficiently screwed
•
deep into the
chuck.
Slide the shaft of the chuck on the drill
•
Press the chuck by turning it slightly left / right on the drill spindle on
•
until it snaps into
To check whether all the drills are in the desired length you can hang up a
profile strip on the drill
The inaccurate drill readjust or replace with new drills.
NOTE:
The machine will not operate before the pressure gauge indicates the correct pressure of
approximately
6-8
bar. Other pressure settings can cause damage to the machine
HOLZMANN MASCHINEN GmbH
place.
Fig. 3
bits.
www.holzmann-maschinen.at
MULTI-DÜBELBOHRMASCHINE / SINGLE-RAW MULTI-BORING MACHINE / TALADRO MULTIPLE DBM 21N
Fig. 1
spindle.
Fig. 2
ASSEMBLY
Fig. 2
Fig. 3
Seite 32
Publicidad
