HOLZMANN MASCHINEN DBM 21N Instrucciones De Servicio página 41

15.1 Lubrication
Occasionally wipe clean guide rods and cylinders. If there is
an appreciable build-up of dust, dirt or wood shavings.
Grease the boring head tilting trunnion through the two
grease fittings at opposite sides of the frame (Fig. 24). Use a
good quality general-purpose grease.
Grease the gears within the boring head, using the two grease
fittings at the back of the boring head (Fig 25)
15.2 Cleaning
The use of solvents, harsh chemicals or abrasive cleaners leads to damage to the machine!
Therfore: When cleaning water and mild detergent if necessary use.
Bare surfaces of the machine against corrosion impregnate ( with anti-rust WD40 )
15.3 Disposal
Do not dispose of the DBM 21N in residual waste. Contact your local
authorities for information regarding the available disposal options. When you
buy at your local dealer for a replacement unit, the latter is obliged to exchange
your old
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
MULTI-DÜBELBOHRMASCHINE / SINGLE-RAW MULTI-BORING MACHINE / TALADRO MULTIPLE DBM 21N
N O T E
MAINTENANCE
Fig. 24
Fig. 25
Seite 41