Publicidad
Idiomas disponibles
Idiomas disponibles
15
MAINTENANCE
Don't clean or do maintenance on the machine while it is still connected to the
power supply:
Damages to machine and injuries might occur due to unintended switching on of
the machine!
Therefore: Switch the machine off and disconnect it from the power supply be-
fore any maintenance works or cleaning is carried out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all con-
necting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the saw band and the saw band guide.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
Always keep oil in the lubricator cup (Fig. 23) to
at least 80 percent of full cup capacity.
Unscrew and remove the oil plug (Fig. 24) with a
flat head screwdriver, and add oil through the
inlet port. Use standard air tool oil. Always re-
install the oil plug after adding oil.
The water filter cup (Fig 24) collects moisture
from the air line. Periodically remove any water
that collects in the water filter cup by pushing up
the release valve at the bottom of the cup.
If the power cord is worn, cut, or damaged in
any way, have it replaced immediately.
The table surface must be kept clean and free of rust results.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
MULTI-DÜBELBOHRMASCHINE / SINGLE-RAW MULTI-BORING MACHINE / TALADRO MULTIPLE DBM 21N
A T T E N T I O N
Fig. 22
Fig. 23
MAINTENANCE
Seite 40
Publicidad
