Maytag Amana Easy Touch Control 500 Guía De Uso Y Cuidado página 6

S oothtop Sucface
Smoothtop Surface Notes:
, Cooktop may emit light smoke and odor the first few
times the cooktop is used. This is normal
, Smoothtop cooktops retain heat for a period of time
after the element is turned off. Turn the dements off
a few minutes before food is compHeteHy c ooked and use
the retained heat to compHete cooking. When the hot
surface Hightturns off, the cooking area wiHH be cooH
enough to touch. Because of the way they retain heat, the
smoothtop dements wiHH not respond to changes in
settings as quickHyas coiHdements.
° In the event of a potentiaHboiHover,remove the pan from
the cooking surface.
, Never attempt to lift the cooktop.
° The smoothtop surface may appear discolored when it is
hot. This is normaHand wiHH disappear when the surface
cooHs.
Cooking Areas
The cooking areas on your range are identified by permanent
circHeson the smoothtop surface. For most efficient cooking,
fit the pan size to the dement size.
Pans should not extend more than V2 to 7-inch beyond
the cooking area.
When a control is turned on, a gHowcan be seen through the
smoothtop surface. The element will cycle on and off to
maintain the preset heat setting, even on High.
For more information on cooP, w are, refer to Cookware
Recommendations on page 6 and "Cooking Made Simple"
bookHetincHudedwith your range.
.911VK_LE
EL b-MEN T
LTU4L ELEMEIVT
{.9ELEO T MODEL 6_
Hot Surface Light
The Hot Surface indicator Hightis Hocatedon the
controHpanel The HightwiHH be iHHuminated
Her; Sue'face
when any cooking area is hot. It wiHH remain on,
even after the controH is turned off, untiHthe area has cooHed.
Tips to Protect the
Smoothtop Surface
CJeaning (see page 18 for more information}
, Before first use, clean the cooktop.
° Clean your cooktop daily or after each use. This will keep
your cooktop looking good and can prevent damage.
° If a spillover occurs while cooking, immediately clean the
spill from the cooking area while it is hot to prevent a tough
cleaning chore later. Using extreme care, wipe spill with a
clean dry towel
° Do not allow spills to remain on the cooking area or the
cooktop trim for a long period of time.
° Never use abrasive cleansing powders or scouring pads
which will scratch the cooktop.
° Never use chlorine bleach, ammonia or other cleansers not
specifically recommended for use on glass-ceramic.
To Prevent Marks and Scratches
° Do not use glass pans. They may scratch the surface.
° Never place a trivet or wok ring between the surface and
pan. These items can mark or etch the top.
° Do not slide aluminum pans across a hot surface. The pans
may leave marks which need to be removed promptly. (See
Cleaning, page 18.}
° Make sure the surface and the pan bottom are clean before
turning on to prevent scratches.
° To prevent scratching or damage to the glass-ceramic top,
do not leave sugar, salt or fats on the cooking area. Wipe
the cooktop surface with a clean cloth or paper towel
before using.
° Never slide heavy metal pans across the surface since
these may scratch.
To Prevent Stains
, Never use a soiHeddish cHothOFsponge to dean the
cooktop surface. A film wiHH remain which may cause stains
on the cooking surface after the area is heated.
° ContinuousHycooking on a soiHedsurface mayiwiHH resuHtin
a permanent stain.
To Prevent Other Damage
° Do not aHHow pHastic,sugar OFfoods with high sugar content
to meritonto the hot cooktop. ShouHdthis happen, dean
immediateHy. (See CHeaning,page 18.}
° Never Hota pan boiHdry as this wiHH damage the surface and
pan.
5