RIDGID R48630 Manual Del Operador página 15

ADJUSTMENTS
 Check the squareness of the saw blade to the base of
the saw using a carpenter's square.
If the blade is not an exact 90° (0° bevel):
 Loosen the bevel lock knobs.
 Turn the zero degree adjusting screws (2) and adjust base
until square with saw blade.
 Tighten the bevel lock knobs securely.
Once blade is square to the base (0° bevel):
 Check bevel indicator.
 If indicator is not pointing to the 0º mark on the bevel
scale, loosen the indicator adjusting screw and adjust
indicator.
NOTE: Tilt the saw to 45° and recheck indicator.
 Retighten screw.
To check for squareness, 45˚ bevel:
 Loosen the bevel lock knobs and tilt the saw to 45°.
 Tighten the bevel lock knobs.
 Lower the blade completely.
ACCESSORIES
Look for these accessories where you purchased this product or call 1-866-539-1710:
 55 in. Track Assembly (incl. four connectors, set screws, and rubber cut strips) ................................................. AC55TS
 60 in. Track Assembly (incl. two connectors, set screws, and rubber cut strips) .................................................. AC60TS
 Track Connector Assembly (incl. two connectors and set screws) ...................................................................204347009
 55 in. Rubber Cut Strip ......................................................................................................................................565347002
 60 in. Rubber Cut Strip ......................................................................................................................................565347003
 6-1/2 in. Blade ...................................................................................................................................................682780001
 Track Clamp Assembly ............................................................................................................................................ ACCL2
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any attach-
ments or accessories not recommended by the manufacturer of this product. The use of attachments or acces-
sories not recommended can result in serious personal injury.
 Place the saw in an upside down position on a work-
bench.
 Check the squareness of the saw blade to the base of
the saw using a combination square.
If the blade is not an exact 45°:
 Loosen the bevel lock knobs.
 Turn the 45° degree adjusting screw and adjust base until
square with saw blade.
 Check and repeat until square.
 Tighten the bevel lock knobs.
Once blade is 45° to the base:
 Check bevel indicator.
 If indicator is not pointing to the 45º mark on the bevel
scale, loosen the indicator adjusting screw and adjust
indicator.
NOTE: Tilt the saw to 0° and recheck indicator.
 Retighten screw.
15 – English