RIDGID R48630 Manual Del Operador página 6

FEATURES
PRODUCT SPECIFICATIONS
Motor ...................................................................... 18 V DC
Blade Diameter ....................................................... 6-1/2 in.
Blade Arbor ............................................................... 5/8 in.
Track Length ....................................................27.5 in. each
Bevel Capacity ...................................................... -1˚ to 47˚
No Load Speed .........................................5,000/min (RPM)
ASSEMBLY
UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
 This saw has been shipped with a tie-wrap securing it in
the plunge position. To release the saw, push down on
the top of the front handle, cut the tie-wrap, and slowly
allow the saw to raise to its fully raised position.
WARNING:
The saw's body is spring loaded. Hold the front
handle down to prevent it from snapping up when
cutting the tie-wrap. Failure to do so could result
in possible serious injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not oper-
ate this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
Cutting Depth at 0º
with track .......................................................... 2-1/8 in.
without track ..................................................... 2-1/4 in.
Cutting Depth at 45º
with track .......................................................... 1-1/2 in.
without track ..................................................... 1-5/8 in.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the product when assembling parts.
INSTALLING THE BLADE
See Figures 1 - 4, page 18.
WARNING:
A 6-1/2 in. blade is the maximum blade capacity of
the saw. Never use a blade that is too thick to allow
outer blade washer to engage with the recesses on
the inner blade washer. Larger blades will come in
contact with the blade guard, while thicker blades
will prevent blade screw from securing blade on
spindle. Either of these situations could result in a
serious accident.
 Remove the battery pack from the saw.
 Remove the large wrench from the storage area.
NOTE: Two wrenches are included with the saw, a small
one for the track and a large one for the blade.
 Place the plunge control lever in the blade change
position.
 Press and lower the depth of cut button to the lowest
setting on the depth of cut scale.
 Grasp the front handle and apply downward pressure to
expose the blade screw. In this position, the saw cannot
be lowered or raised.
6 – English