Publicidad
Idiomas disponibles
Idiomas disponibles
Reinstall the
plastic cover
1
Pump
drain hose
Reinstall the plastic cover and
install the pump drain hose.
Press the pump pad of the unit to activated the pump operation. When the bucket is full the pump starts to work.
Note: The pump may cause big noise when it starts to work for 3~5 minutes. It is a normal phenomenon.
Make sure the hose is secure so there are no leaks.
Direct the hose toward the drain, making sure that there are no kinks that will stop the water flowing.
Place the end of the hose into the drain and make sure the end of the hose is level or down to let the water flow smoothly. Do never let it up.
select the desired humidity setting and fan speed on the unit for pump draining to start.
Note: The pump operation on light blinks at 1Hz when the pump is operational failure. Please turn off the unit and plug the power cord out. Check the
following things: Cleaning the filter of the pump.-Remove the bucket from the unit, take down the pump and clean the filter of the pump.
Check that the pump drain hose does not link or back.
Empty the water of the bucket.
Reinstall the pump hose if it drops and reinstall the bucket properly. Turn on the unit. If the error repeats, call for service.
Note: Do not use this operation when the outdoor temperature is equal to or less than 0 °C (32°F),
otherwise water is become ice that will cause the water hose blocked up and the unit failure. Make sure to empty the bucket once a week when using the
pump draining feature. When the pump draining feature is not being used, remove the pump drain hose from the outlet.
Press the pump drain hose outlet in and take the pump drain hose out from it. Make sure do not let the water in the pump hose drip to the floor.
2
Pump drain
hose outlet
Clean the filter pump after you have
used the pump function several times.
18
Filter of the pump
Publicidad
