DeWalt DCF620 Manual De Instrucciones página 8

• Do not operate the charger if H has received a sharp blow,
been dropped or otherwise damaged in any way. Take it to
an authorized service center.
• Do not disassemble the charger; take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 120V
household electrical power. Do not attempt to use ff on any
other voltage. This does not apply to the vehicular charger.
Chargers
Your tool uses a DEWALT charger. Be sure to read all safety
instructions before using your charger. Consult the chart at the end of
this manual for compatibility of chargers and battery packs.
Charging Procedure (Fig. 1)
1. Plug the charger into an appropriate FIG. 1
outlet before inserting battery pack. F
2. Insert the battery pack (F)into
the charger, as shown in Figure 1,
making sure the pack is fully seated
in charger. The red (charging)light
will blink continuously indicating that
the charging process has started.
3. The completion of charge will be
indicated by the red light remaining
ON continuously. The pack is fully
charged and may be used at this time
or left in the charger.
Indicator Light Operation
DCB101
PACK CHARGING
PACK CHARGED
-HOT/COLDDELAY--o --o _o --o --e
PROBLEM PACK ORCHARGERo • • o • • • • • •
PROBLEMPOWERLINE ee eo ee ee eo
DCB112
i[_ PACK CHARGING
[_ PACK CHARGED
Charge Indicators
This charger is designed to detect certain problems that can arise.
Problems are indicated by the red light flashing at a fast rate. If this
occurs, re-insert the battery pack into the charger. If the problem
persists, try a different battery pack to determine if the charger is
working properly. If the new pack charges correctly, then the original
pack is defective and should be returned to a service center or other
collection site for recycling. If the new battery pack elicits the same
trouble indication as the original, have the charger and the battery
pack tested at an authorized service center.