Goodyear GY 09ATK Manual De Instrucciones página 21

English
Owner´s manual
•
6. TROUBLESHOOTING
Problem
The tool has low RPM
and/or does not work.
:
ATTENTION
Do not make any modifications to the machine that could damage its operation. Any
alteration or modification will invalidate the product warranty. If your device continues to give errors or
presents any type of problem other than those indicated above, please contact our technical
service so that our team can advise you and solve the problem.
7. TECHNICAL DATA
MODEL
Air Consumption (l/min)
Piston Stroke (mm)
Max. working pressure (bar- PSI)
Blow per minute (BPM)
Chisels
Air intake thread
Material
Dimensions of the air hammer
Air hammer weight (without
accesssories)
Possible cause
Tool not lubricated.
Low air pressure.
Low speed and capacity of the
equipment.
Leakage in the air hose.
Equipment with humidity.
Inadequate lubrication
Solution
Check that the pneumatic lubricator
is working properly.
Set the equipment to maximum
pressure. (6.3bar - 90 PSI).
Replace the hose with one of the
proper diameter.
Replace the hose.
Empty the compressor tank, as it
may contain moisture inside.
Check the lubrication procedure
contained in this manual.
GY 09ATK
141 l/min
66 mm
6,3 bar - 90 PSI
3500bpm
5 pcs - 175 mm
1/4"
Aluminum
188x149x48mm
1,3kg
21