Publicidad
Idiomas disponibles
Idiomas disponibles
Switching
on and off (fig. J)
For your safety, this tool is equrpped with a double switching
system. This system prevents starting the toot inadvertently.
A chain saw is intended for two-handed use. Serious injury to the
operator, helpers, and/or bystanders can result from one-handed
operation.
Switching
on (fig. K)
To open the handles, slide the latch (5) backwards and pull the
handles apart. Ensure a firm grip on the handles and then squeeze
both switch actuators to switch the unit on.
Note: Both switches must be activated for the product to be used.
Do not force the tool - allow it to do the work. It will do a better and
safer job at the speed for which it is designed. Excessive force wilt
stretch the chain.
If the saw chain or bar becomes jammed:
- Switch the tool off.
- Remove the battery from the toot.
- Open the cut with wedges to relieve the strain on the guide bar.
Do not try to wrench the saw free. Start a fresh cut.
After use, close the handles and slide the latch (5) forward to the
lock position. The handles should be locked during transportation
and storage.
Trimming
branches
- Make sure the tool is running at full speed before making a cut.
- Hold the tool firmly in place to avoid possible bouncing or
sideways movement of the toot.
- Guide the tool using light pressure.
- Always cut down from the top. This way you wilt avoid pinching
the saw chain.
= Remove branches
as shown in Fig L. Starting from branch tip
reduce the branch in logical steps cutting off small sections. "When
cutting a limb that is under tension be aware of spring back.
- When the tension in the wood fibres are released the spring
loaded limb may strike the operator and/or throw the tool out of
control"
- Remove the tool from the cut while it is running at full speed.
Maintenance
Your Black & Decker tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
z_WARNING:
Before performing any maintenance or cleaning of
the tool, remove battery from the tool.
Cleaning
- Regularly remove the chain access cover and remove any debris
that has become trapped.
Regularly clean the ventilation slots with a clean, dry paint brush.
- To clean the tool, use only mild soap and a damp cloth. Never let
any liquid get inside the tool and never immerse any part of the tool
into liquid.
Oiling
Regularly oil the oiling points (16) as indicated in figure I.
Transporting
- Always transport the tool with the jaws closed and the latch in the
locked position.
Saw Chain
Sharpening
CAUTION: Sharp chain. Always wear protective
gloves when
handling
the chain. The chain is sharp and can cut you when it is
not running.
z_ WARNING: Sharp moving chain. To prevent accidental
operation, insure that battery is disconnected
from the tool
before performing the following
operations.
Failure to do this
could result in serious personal injury.
To get the best possible performance from your chain saw it is
important to keep the teeth of the chain sharp. Follow these helpful
tips for proper saw chain sharpening:
1. Remove the saw chain and use a chain vise when doing any
sharpening. See "Removing the saw chain and chain bar".
2. For best results use a 4.5mm file and a file holder or filing guide
to sharpen your chain. This will ensure you always get the correct
sharpening
angles.
12
Publicidad
