MTD 450 Serie Manual Del Operador página 10

Controls a nd Features
4
Hopper
Chipper Chute
Release Rod
"\\\\\\
Tow Bart
t if Equipped
@
Model Series 460 Shown
Figure 4-1
J
Chipper Chute
Allows twigs and small branches up to 3" (2" for Model Series
450) in diameter to be fed into the impeller for chipping. See Fig.
4-1.
Hopper
Allow leaves and small branches up to 1/2 diameter to be fed into
the impeller for chipping and shredding. Material can be raked
into the hopper by lowering it down to the ground.
Release Rod
The release rod is located on the impeller bracket assembly and it
is used to release or lock the hopper when raising or lowering.
TowBar (if Equipped)
Use the tow bar to tow the chipper shredder behind a tractor to a
job site. See Fig. 4-1.
NOTE: If your unit is not equipped with a tow bar, you may
contact Customer Support as instructed on page 2 for
information regarding price and availability.
RecoilStarter
The recoil starter is located on the engine. Pull the recoil starter
to start engine.
EngineControls
See the engine Owner/Operator manual packed with your unit
for the location and function of the controls on the engine.