MTD 450 Serie Manual Del Operador página 9

4_
Secure chipper chute with the three cupped washers Bag
(cupped side against the chipper chute) and hex nuts
1.
previously removed. See Fig. 3-6B. Do not tighten the nuts
at this time.
The chipper shredder was shipped with one end of the support
brace already secured to the lower frame. Loosen but do not
remove the bolts securing the brace to the frame.
5. Align the holes in the chute with the holes in the top of the
brace and attach brace to chipper chute with hardware
previously removed. The flat washers should be placed
under the bolt heads and against the inside surface of the
plastic chipper chute. See Fig. 3-7A. Tighten securely.
/ /
/
/
/
/
/
/ /
/'
/
/
/
Figure 3-7
6. Tighten the bolts securing the support brace to the frame.
See Fig. 3-7B.
7. Tighten the three nuts on the weld studs holding the
chipper chute to the impeller housing. See Fig. 3-7C.
Place the opening of the bag completely over the chute
deflector. See Fig. 3-8A.
\
Figure 3-8
2. Pull on the drawstring until the bag is tight around chute
deflector opening. See Fig. 3-8B.
3. Clip drawstring back on itself, tight against chute deflector
to secure into position. See Fig. 3-8C.
Set-Up
(;as and 0il Fill-Up
Refer to the separate engine owner's manual for additional
engine information.
1. Add oil provided before starting unit for the first time out
of the box.
2_
Service the engine with gasoline as instructed in the
separate engine owner's manual.
WARNING: Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
_ WARNING: Never fill fuel tank indoors with engine
running or until the engine has been allowed to cool
for at least two minutes after running.
SECTION
3 -- ASSEMBLY& SET-UP 9