Toyotomi FF-55T Instrucciones De Uso página 30

A) Before commencing any installation work, check that the proposed installation will comply with Building Code
requirements and Local Consent Authority rules that may apply to vented heaters in your area. (Check your
Local Authority website, or consult your Installer / Supplier.)
B) The Flue Pipe is designed to be installed through the wall of any conventional building cladding, including
Brick, Hebel, Linear, Gibraltar and Plaster Board, Tiles, Weatherboard, Plastered Polystyrene, and metal
profiles etc.
C) The FF-55T / FF-55 heater is designed to be operated at altitudes up to 1,000 m, above sea level. For
installation at altitudes between 1,000 m and 1,500 m, adjustments by authorized serviceperson is necessary.
Consult your supplier for advice.
1. Select heater location. Ensure minimum clearances as indicated below between heater and nearest
combustible materials. Provide service access to clean the rear circulation air filter, fuel strainer (FF-55) and red
float release button(FF-55).
2. Ensure the outdoor flue discharge area is clear of anything that might be affected by the hot flue exhaust gas.
(See Fig. 2 and 3.)
The Flue Pipe (as in Fig. 2), is for wall thickness from 130 mm to 320 mm.
3. A room temperature sensor is provided with approx. 2.5 m long extension wire. It is
located on the rear of the cabinet. Make sure that the extension wire is not touching
the exhaust pipe. The room temperature sensor can be installed with a wood screw.
Screw down the wood screw provided with the heater into the desired location on
the wall. Hook the back of the room temperature sensor.
NOTE: Choose a location for the sensor that is not in the path of direct sunlight,
drafts or the flow of warm air from the heater.
Read installation manual before installing heater.
GB
24
FF-55T_FF-55_Type E_6 language_A4.indb 24
INSTALLATION OF HEATER AND FLUE PIPE
More than
30 cm
More than
150 cm
Flammable object
Flammable object
Not less than 60 cm
Non-flammable
object
45˚
Not less than 30 cm
Exhaust pipe
Not less than 20 cm*
Fig. 2
Flue Pipe Installation
More than
60 cm
More than
10 cm
More than
30 cm
FF-55T / FF-55
Fig. 1
Not less
Not less than 60 cm
than 45 cm
* Be sure this clearance
will be maintained after
snow-falls, etc.
Fig. 3
ENGLISH
Not less
than 45 cm
2023/06/21 9:20:46