Publicidad
SERVICE AND ADJUSTMENT
HOW TO INSTALL THE MOWER
HOUSING
HOW TO REMOVE
THE MOWER
HOUSING
1.
Move the attachment clutch to the DISENGAGE
position.
2.
Move the lift lever to the level adjustment position (Figure 32).
3,
4,
5,
6.
7.
8.
9.
NOTE: Make sure the lift lever
is
locked
in
the
LEVEL
ADJUSTMENT
position.
Remove the hair pins and the
washers from the rear suspen-
sion arms (Figure 33). See il-
lustrations "C" and "D".
Level Adjustment
Remove the hair pins and wash-
Position
Figure 32
ers from the suspension
links.
See illustrations "A" and "B".
Disconnect the extension
spring from the blade control
rod.
See illustration "E".
Disconnect
the front
hanger
from the frame support. See
illustration "F".
Remove the mower
drive
belt from the stack pulley. See
illustration "G".
Pull the mower housing away from the right side of the unit.
To operate without the mower housing, move the lift lever to the
TOP position.
1.
Push the mower housing under the right side of the unit.
2.
Put the mower drive belt around the stack pulley. Make sure
the 'V' side of the mower drive belt is against the stack pulley.
Also, make sure the mower drive belt is not twisted.
3.
Attach the front hanger to the frame support with the hanger
rod. Fasten with the fasteners as shown. See illustration "F".
4.
Make sure the mower drive belt is between the stack pulley
and the two belt guides. See illustration "G".
5.
Attach the suspension
links to the lifter assembly.
Fasten
with the washers and hair pins. See illustrations "A" and "B".
6.
Attach the rear suspension
arms to the suspension brackets.
Fasten with the washers and hair pins. See illustrations "C" and
,,D _"
7.
Attach the extension
spring
to the blade control
rod. See
illustration "E".
8.
Move the attachment
clutch to the ENGAGE position. Make
sure the mower drive belt is inside all the belt guides and is
also below the spacer tube.
9.
Make sure the mower housing is level. See the instructions on
"How To Level The Mower Housing".
10. Check the operation of the attachment
clutch. See the instruc-
tions on "How To Adjust The Attachment
Clutch".
Lift Lever
Attachment
Clutch
Tube
BeltGuide
I
Stack Pulley
j
Adjuster
Arm
C
D
Adjuster
Arm
Lifter
Assembly
Mower
Drive Belt
o
_
Suspension
Link
B
Front Hanger
Hanger Rod
Suspension
Link
I__
Extension
Spring
Figure 33
400150
30
Publicidad
