Proxxon OZI 220/E Manual página 6

PROXXON - OZI 220/E
GB
Dear Customer,
Before putting the machine into
operation, read the enclosed safety rules
and operating instructions.
Legend
1. Grinding pad
2. Screw
3. Speed adjust button
4. ON/OFF switch
5. Hoop
6. Connection cable with power plug
7. Vent slits
Machine description
The PROXXON MICROMOT OZI 220/E
corner grinder is ideal for grinding
difficult-to-reach areas, such as corners,
edges, joints and cavities. Thanks to the
oscillating grinding plate (Fig. 2), better
grinding results are achieved than are
possible using corner grinders that
operate with eccentric action. Additional
attach-ments can be fitted, such as
circular saw blades or diamond cutting
blades to disaggregate the most
disparate materials in inaccessible areas.
This machine features:
• Housing crown made of diecast
aluminium for precision ball bearing fit
and increased durability under extreme
loads.
• Quiet-running, enclosed ventilated 5-
pole full-wave electronic motor (5,000
to 10,000 rpm).
• Grinding pad with velcro facing for
quick replacement of grinding wheels.
- 6 -
Technical data
Motor:
Voltage
Power consumption
Short-time operation
Rotational speed
Weight
Characteristic noise
Noise level may exceed
85 dB(A) during operation.
Ear protection must be worn!
Vibration at handle
Class 2 protective insulation
For use in dry environments only
Protection class II device
Please do not dispose
off the machine
!
Proper handling of the machine
Replacing grinding wheel
1. Hold grinding wheel at one corner (Fig.
3) to remove.
2. Place new grinding wheel on grinding
pad to fit, and then press on firmly.
Note:
Replace dull grinding wheels promptly.
To make optimal use of individual
grinding wheels, offset wheels 120° after
each use.
Removing, installing and rotating
grinding pad
It may be necessary to rotate the
grinding pad to access hard to-reach
areas.
~ 220-240 V
100 Watt
KB 15 min
3,000 to
10,000 rpm
approx. 590 g
LPA 83dB(A)
LWA 96dB(A)
2
< 2.5 m/s