Publicidad
Idiomas disponibles
Idiomas disponibles
C
Troubleshooting
IMPORTANT:
Before troubleshooting, disconnect the power supply. Only
a qualified electrician of competent person must do the
troubleshooting that is not in this manual.
There are some sounds during normal use (compressor,
refrigerant circulation).
Problem
Appliance does not
work
Appliance cools too
much
The food is too warm.
Unusual noises
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here,
refer to the rating plate.
Useful information
Possible cause
Mains plug is not plugged in or is
loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or the
appliance runs at Super modes.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat source.
Appliance is not level.
The appliance is touching the wall
or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or the
wall.
21
Insert mains plug.
Check fuse replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Please look in the installation
location section.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
EN
Solution
Publicidad
