Publicidad
Idiomas disponibles
Idiomas disponibles
Splash guard
► Fig.44
Reduces splash back when cleaning corners with the
cyclone jet nozzle.
► Fig.45: 1. Nut 2. Cyclone jet nozzle
When using the splash guard, remove the nut from the
splash guard, then insert the cyclone jet nozzle into the
splash guard, and then tighten the nut.
Foam nozzle
► Fig.46
Detergent can be sprayed as foam.
Wash brush
► Fig.47
A nozzle equipped with a brush. Useful for washing out
dirt while scrubbing with brush.
Variable nozzle
CAUTION:
When adjusting the jet width, do
not rotate the nozzle while pulling it toward the
trigger gun. The nozzle may come off from the trig-
ger gun and cause a personal injury.
CAUTION:
When rotating the tip of the nozzle
to adjust the water jet, do not rotate it forcibly.
Otherwise, the nozzle may break and cause an injury.
► Fig.48
Jet width can be adjusted from 0° to 25° by rotating the
front end of the nozzle.
Rotating brush
► Fig.49
Three brushes inside rotate slowly when ejecting the
jet. Suitable for cleaning light dirt on an exterior wall, car
body, bath tub, etc.
Under body spray lance
CAUTION:
Do not use the under body spray
lance with the lance extension.
► Fig.50
An extra long spray lance with angled nozzle. Best for
cleaning hard-to-reach areas such as car under body
and roof gutter.
Pipe cleaning hose
(10 m/15 m (32.8 ft./49.2 ft.))
CAUTION:
Pay particular attention to the
water jet when using the pipe cleaning hose.
Highly intense water jet is ejected backward. Only
trigger the water jet when the nozzle has been
inserted into the pipe to be cleaned at least up to
the red marking.
► Fig.51
For cleaning and unclogging plumbing and downpipes.
Connecting joint
► Fig.52
A joint to connect with a nozzle from other model.
Some optional nozzles require the connecting joint
(optional accessory) to attach to the trigger gun. Attach
the connecting joint to the trigger gun in the same way
as the nozzle.
► Fig.53: 1. Nozzle 2. Connecting joint 3. Trigger gun
Lance extension
► Fig.54
Pipes to extend the length of the trigger gun. Three
different lengths are available by changing the number
of the pipes to be used.
Extension high-pressure hose
(5 m/8 m/10 m (16.4 ft./26.3 ft./32.8 ft.))
► Fig.55
Extension hose to connect the high pressure washer
body with the trigger gun.
Swivel joint
► Fig.56
Prevents the high-pressure hose from being twisted.
► Fig.57: 1. Button 2. Nut
To connect or disconnect the high-pressure hose to or
from the swivel joint, turn the nut on the high-pressure
hose while pressing the button on the swivel joint.
Hose assembly
► Fig.58
A hose assembly to connect a faucet to the product, or
the strainer assembly to the product.
Strainer assembly
► Fig.59
A strainer assembly to supply water from a tank or
reservoir. Use the hose assembly to connect to the
product.
MAKITA LIMITED WARRANTY
Please refer to the annexed warranty sheet for the
most current warranty terms applicable to this product.
If annexed warranty sheet is not available, refer to the
warranty details set forth at below website for your
respective country.
United States of America: www.makitatools.com
Canada: www.makita.ca
Other countries: www.makita.com
22 ENGLISH
Publicidad
