HERKULES 43.406.72 Manual De Instrucciones página 17

Anleitung FKS 2201_SPK7:Anleitung FKS 2200 SPK 7
dimension and clamp it in place on the sliding
table (3).
Press the workpiece firmly against the cross stop
(7) and push the sliding table slowly toward the
blade.
Always push the sliding table (3) forward to the
point where the workpiece is cut all the way
through.
Switch off the saw again. Important: Do not
remove the offcut until the blade (4) has stopped
rotating.
9.2.2 Making edging cuts with the sliding table
(28)
Pull the sliding table (3) forward.
Place the workpiece on the sliding table and
press it firmly against the edging plate (c)
Push the sliding table (3) with the workpiece
toward the blade and make the cut.
10.0. Maintenance
Important! Pull out the power plug first.
Remove dust and dirt regularly from the
machine. Cleaning is best carried out with a fine
brush or a cloth.
Never use caustic agents to clean plastic parts.
11.0. Ordering replacement parts
Please provide the following information on all orders
for replacement parts:
Model/type of device
Article number of the device
ID number of device
Number of the required replacement part
For our latest prices and information please go to
www.isc-gmbh.info
16.11.2006 14:20 Uhr Seite 17
GB
17