Craftsman 917.28634 Manual Del Operador página 19

TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and termi-
nals can cause the battery to "leak" power.
1, Disconnect BLACK battery cable first
then RED battery cable and remove
battery from tractor.
2. Rinse the battery with plain water and
dry.
3. Clean terminals and battery cable ends
with wire brush until bright.
4. Coat terminals with grease or petro-
leum jelly,
5. Reinstall battery (See "REPLACING
BATTERY in the SERVICE AND AD-
JUSTMENTS section of this manual).
TRANSAXLE COOLING
The transmission fan and cooling fins
should be kept clean to assure proper
cooling,
Do not attempt to clean fan or transmis-
sion while engine is running or while the
transmission is hot, To prevent possible
damage to seals, do not use high pressure
water or steam to clean transaxle,
• Inspect cooling fan to be sure fan blades
are intact and clean.
• Inspect cooling fins for dirt, grass clip-
pings and other materials. To prevent
damage to seals, do not use com-
pressed air or high pressure sprayer to
clean cooling fins.
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory
and fluid maintenance is not required for
the life of the transaxle. Should the trans-
axle ever leak or require servicing, contact
your nearest Sears or other qualified
service center,
V-BELTS
Check V-belts for deterioration and wear
after 100 hours of operation and replace
if necessary, The belts are not adjustable.
Replace belts if they begin to slip from
wear.
ENGINE
LUBRICATION
Only use high quality detergent oil rated
with API service classification SG-SL
Select the oil's SAE viscosity grade
according to your expected operating
temperature.
f __J I siEvrsc°s_e_°Es ....
I F .28 0 30 32 40 59 _f0 100
I C _0 -2_ +1; 0 t0 2{} 30 4_
[ TEMPERATORE RANQE ANT1CEPATED BEFORE NEX_"6i['cHANGE
NOTE: Although multi-viscosity oils
(5W30, 10W30 etc.) improve starting in
cold weather, they will result in increased
oil consumption when used above 32°E
Check your engine oil level more frequent-
ly to avoid possible engine damage from
running low on oil.
Change the oil after every 50 hours of op-
eration or at least once a year if the tractor
is not used for 50 hours in one year°
Check the crankcase oil level before start-
ing the engine and after each eight (8)
hours of operation. Tighten oil fill cap/
dipstick securely each time you check the
oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected
before oil change. Atl oil must meet API
service classification SG-SL
• Be sure tractor is on level surface.
• OiI will drain more freely when warm,
• Catch oil in a suitable container.
1. Remove oil fill cap/dipstick, Be careful
not to allow dirt to enter the engine
when changing oil
2. Remove yellow cap from end of drain
valve and install the drain tube onto the
fitting,
Oil Drain Valve
Closed
and
Locked
Position
Yellow Cap
Drain Tube
3, Unlock drain valve by pushing inward
slightly and turning counterclockwise.
4, To open, pull out on the drain valve,
5. After oil has drained completely, close
and lock the drain valve by pushing
inward and turning clockwise until the
pin is in the locked position as shown.
6. Remove the drain tube and replace the
cap onto the end of the drain valve,
7, Refill engine with oil through oil fill dip-
stick tube. Pour slowly. Do not overfill.
For approximate capacity see "PROD-
UCT SPECIFICATIONS" section of this
manual.
I9