Descargar Imprimir esta página

Craftsman 917.28634 Manual Del Operador página 29

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
CHART:
See appropriate
section
in manual
unless directed
to Sears
service
center
PROBLEM
CAUSE
CORRECTION
Will not start
1, Out of fuel
2,
Engine not "CHOKED"
properly.
3,
Engine flooded,
4,
Bad spark plug,
5,
Weak or dead battery,
6o Dirty air filter,
, Dirty fuel filter,
Water in fuel
9,
Loose or damaged
wiring
1.
Fill fuel tank,
2. See "TO START ENGINE"
in
Operation
section.
3. Wait several
minutes
before
attempting
to start.
4o Replace spark plug
5,
Recharge
or replace
battery,
6
Clean/replace
air filter.
7,
Replace fuel filter,
8,
Empty fuel tank and carbure-
tor. refill tank with fresh gas-
oline and replace
fuel filter,
9, Check
all wiring.
I O,See "To Adjust Carburetor"
in Service
and Adjustments
section.
11 ,Contact
a Sears or other
qualified
service
center.
1O, Carburetor
out of adjustment.
11_Engine valves out of
adjustment,
Hard to start
1, Dirty air filter.
2.
Bad spark plug,
3.
Weak or dead battery,
4,
Dirty fuel filter.
• Stale or dirty fue!,
6,
Loose or damaged
wiring,
t,
Clean/replace
air filter,
2.
Replace
spark plug,
3.
Recharge
or replace
battery,
4.
Replace fuel filter,
5,
Empty fuel tank and refill tank
with fresh, clean gasoline,
&
Check
all wiring.
Engine
will not
turn over
Engine clicks
but
will not start
Loss of power
7,
Carburetor
out of adjustment,
,
Engine valves
out of
adjustment,
2 , Brake pedal not depressed,
Attachment
clutch is engaged,
3,
Weak or dead battery,
4,
Blown fuse,
5,
Corroded
battery terminals,
. Loose or damaged
wiring,
Faulty ignition switch,
8, Faulty solenoid
or starter,
,
Faulty operator
presence
switch(es),
1, Weak or dead battery°
2, Corroded
battery terminals,
3,
Loose or damaged
wiring,
4_ Faulty solenoid
or starter,
1_ Cutting
too much grass/too
fast.
2. Throttle
in "CHOKE"
position,
3_ Build-up
of grass,
leaves and
trash under mower.
4.
Dirty air filter,
5.
Low oil leve!/dirty
oil.
7.
See "To Adjust Carburetor"
in
Service
and Adjustments
section,
8. Contact
a Sears or other
qualified
service
center.
1.
Depress
brake pedal.
o Disengage
attachment
clutch.
3,
Recharge
or replace
battery.
4,
Replace
fuse.
5, Clean
battery terminals.
6.
Check all wiring.
7,
Check/replace
ignition switch.
8.
Check/replace
solenoid
or
starter.
9_ Contact
a Sears or other
qualified
service
center.
, Recharge
or replace
battery
. Clean battery terminals.
3.
Check
all wiring.
4,
Check/replace
solenoid
or
starter.
1, Raise cutting height/reduce
speed.
2. Adjust throttle
control.
. Clean underside
of mower
housing
4.
Clean/replace
air filter.
5.
Check
oil level/change
oil.
29

Publicidad

loading