Husky DPFN64 Manual De Instrucciones página 5

A WARNING:
Use only those fasteners recommended
for use with this tool. Fasteners not
identified for use with this tool by the tool
manufacturer are able to result in a risk of
injury to persons or tool damage when
used in this tool.
A WARNING:
Keep the tool pointed away from yourself
and others when loading fasteners.
Failure to do so could result in possible
serious personal injury.
A WARNING:
Never load fasteners with the workpiece
contact or trigger activated. Doing so
could result in possible serious personal
injury.
UNLOADING FASTENERS
1. Disconnect the tool from air source.
2.Pull back the pusher, pressing bypass lever of
the pusher to allow pusher to bypass nails and
slowly allow pusher to retum to nose of the tool.
(see figure 5)
= 3.Slide the fastener to the rear magazine. Once
the nails have slid back to the hold back spring,
press the tab on the hold back spring to push the
spring back and allow the nails to come out of
the magazine. (see figure 6)
ENGAGE NAILS
ad
Press
W IA bypass lever
A WARNING:
The tool may fire when it is first
connected to the air source. Always
connect the tool to the air source before
loading fasteners to prevent injury from
unintended cycling. Always make sure i
the tool's magazine is empty at the Ape
beginning of each work session, before SLIDE FOR eS
connecting to an air source. pe
CY
RELEASE
_ NAILS
PRESS the nail hold back spring
Latch(C)
Jam release(D)
A WARNING:
Always unload all fasteners before removing
tool from service.
A WARNING:
Always disconnect the air source before
unloading.
CLEARING JAMS
Occasionally, a fastener may become jammed in
the firing mechanism of the tool, making the tool
inoperable. To remove a jammed fastener, follow
the steps below:
1. Disconnect the tool from air source.
2.Remove fasteners from the tool. Failure to do so
will cause the fasteners to eject from the front of
the tool.
3. Pull up on the latch (C) and open the jam release
(D).
4.Using caution not to bend or damage the driver
blade, using pliers or a screwdriver if required to
clear the jammed fastener.
5.Close the jam release and latch.
6. Reconnect the tool to the air source.
7.Reload the tool with fasteners.
A WARNING:
Make sure there is no fastener in
magazine before clearing a jam.
A WARNING:
Disconnect the tool from the air source
whenever clearing a jam. After
disconnecting the tool from the air
compressor, there should still be enough
air pressure to fire the tool. After the air
hose is disconnected, always fire the tool
into scrap wood repeatedly to make sure
all of the compressed air is expended.
NON-MARRING PAD
The no—marring pad attached the nose of the tool
helps prevent marring and denting when working
with softer woods.
A WARNING:
Disconnect the tool from the air source
before removing or replacing the no-
marring pad. Failure to do so could result
in serious personal injury.
To remove the pad: Pull the no mar tip towards the
back of the tool following the bend of the wire nose.
To replace the pad: Push the no mar tip on to the
tool inserting the opening of the no mar tip on to the
wire nose.