Publicidad
Idiomas disponibles
Idiomas disponibles
<YHUSKY
TROUBLESHOOTING
A WARNING:
Stop using tool immediately if any of the following problems occur. Serious personal injury
could result. Any repairs or replacements must be done by a qualified service person or an
authorized service center.
PROBLEMS
Air leaking at trigger
valve area.
POSSIBLE CAUSE(S)
O-rings in trigger valve housing are
damaged
CORRECTIVE ACTION
Replace o—rings. Check operation
of Work Contact Element(WCE)
Air leaking between
housing and nose.
Loose screws in housing
1.Damaged O-rings
2.Damaged to bumper
Tighten screws
1.Replace o-rings
2.Replace bumper
Air leaking between
housing and Cap.
1.Loose screws
2.Damaged gasket
1.Tighten screws
2.Replace gasket
Tool skips driving
fastener
1.Worn bumper
2.Dirt in nose piece
3.Dirt or damage prevent fasteners or
pusher from moving freely in
magazine
4.Damaged pusher spring
5.Inadequate air flow to tool
6.Wom O-ring on piston or lack
of lubrication
7.Damaged O-ring on trigger valve
8.Air leaks
9.Cap seal leaking
1.Replace bumper
2.Clean drive channel
3.Clean magazine
4.Replace spring
5.Check fitting, hose, or compressor
6.Replace and lubricate o-rings
7.Replace o-rings
8.Tighten screws and fittings
9.Replace gasket
Tool runs slow or has
loss of power
1.Tool not lubricated sufficiently
2.Broken spring in cylinder cap
3.Exhaust port in cap is blocked
1.Lubricate nailer
2.Replace spring
3.Replace damaged internal parts
Fasteners are jammed
in tool
1.Guide on driver is worn
2.Fasteners are not correct size
3.Fasteners are bent
4.Magazine or nose screws are loose
5.Driver is damaged
1.Replace guide
2.Use only recommended fasteners
3.Replace with undamaged fasteners
4.Tighten screws
5.Replace driver
14
<YHUSKY
WARRANTY
2 YEARS LIMITED WARRANTY
If within two years from the date of purchase, this Husky air tool product
fails due to a defect in materials or workmanship, please immediately
contact Product Support at 1-866-676-8468
(8am to 5pm EST, M-F,
except normal Holiday).Do not return the air tool to the store. Please be
prepared to send the product, postage prepaid, along with a copy of the
dated
first owner
purchase
receipt with the tool
model
to: PRIME
GLOBAL
PRODUCTS,
INC.
Address:
Ball
Ground,
Ga
30107.
A
defective
product
will
be
promptly
replaced
with
a
new
one
of
equal
or
greater
value.
This
warranty
excludes
incidental/consequential
damages
and
failures
due
to
misuse,
abuse
or
normal
wear
and
tear.
This
warranty
gives
you
specific rights, and you may also have other rights, which vary, from
state to state. Please call 1-866-676-8468 for details.
15
Publicidad
