Publicidad
Idiomas disponibles
Idiomas disponibles
Check Valve: When the air
compressor
is operating, the check
valve is "open", allowing compressed
air to enter the air tank.
When the air
compressor
reaches "cut-out"
pressure, the check valve "closes",
allowing air pressure to remain inside
the air tank.
Pressure Release Valve: The
pressure release valve, located on the
side of the pressure switch, is
designed to automatically
release
compressed
air from the compressor
head and the outlet tube when the air
compressor
reaches "cut-out"
pressure or is shut off. The pressure
release valve allows the motor to
restar_ freely. When the motor stops
running, air will be heard escaping
from this valve for a few seconds.
No air should be heard leaking when
the motor is running or after unit
reaches "cut-out"
pressure.
Air Intake Filter (not shown) This
filter is designed to clean air coming
into the pump. This filter must always
be clean and ventilation openings
free from obstructions.
See
"Maintenance".
How to Use Your Unit
How to Stop:
1.
Set the On/Auto/Off
lever to
"OFF".
Before
First Start-up
Risk of Unsafe
Operation. Serious
damage may result if the following
break-in instructions are not
closely followed.
This procedure is required before the
air compressor is put into service the
first time and when the check valve
or a complete compressor
pump has
been replaced.
Break-in Instructions
1.
2.
Make sure the On/Auto/Off
lever
is in the "OFF" position.
Recheck all wiring. Make sure
wires are secure at all terminals
connections.
Make sure all
contacts move freely and are not
obstructed.
3.
Open the globe valve fully to
permit air to escape and prevent
air pressure build-up
in the air
tank during the break-in period.
4.
Move the On/Auto/Off
lever to
"ON/AUTO"
position. The
compressor
will start.
5.
Run the compressor for 20
minutes. Make sure the globe
valve is open and check tank
pressure gauge for minimal air
pressure build-up in air tank.
6.
Check all air line fittings and
connections/piping
for air leaks
by applying a soap solution to
them. Bubbles will indicate a
leak. Correct if necessary. NOTE:
Minor leaks can cause the air
compressor
to overwork,
resulting in premature breakdown
or inadequate
performance.
7.
Check for excessive vibration.
Readjust or shim air compressor
feet, if necessary.
8.
After 20 minutes, close the globe
valve.The air tank will fill to "cut-
out" pressure and the motor will
stop.
15_ ENG
D30091
Publicidad
