Glacier bay HDQFS6A0235CP Guía De Instalación Y Cuidado página 4

Installation
1
Installing the faucet assembly
WARNING: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old faucet.
□
Clean off the mounting surface.
□
Remove the lock nut (D).
□
WITHOUT DECK PLATE: Insert the supply lines (E)
through the mounting hole in the sink until the
faucet (A) sets on top of the sink.
□
WITH DECK PLATE: Align the hole in the putty plate
(G) and deck plate (F) with the mounting hole in the
sink. Insert the supply lines (E) through the deck
plate (F) and mounting hole in the sink until the
faucet (A) sets on top of the deck plate (F).
F
G
1
NOTE: If the sink is uneven, use silicone under the Putty
plate (G).
A
D
E
A
E
2
2
Securing the faucet
□
Slide the rubber washer (H) and metal washer (I)
over threaded rods (C). Use the lock nuts (D) to
secure the rubber washer (H) and metal washer
(I).
□
Attach the extension rod (not included) to one
lock nut (D), feed a screwdriver (not included)
through the bottom of the extension rod, and then
tighten the lock nut (D). Repeat for the second
lock nut (D).
NOTE: Make sure the faucet (A) and the deck plate (F) are
aligned while tightening the lock nut (D).
1
4
C
2
H
I
D