Glacier bay HDQFS6A0235CP Guía De Instalación Y Cuidado página 8

Operation
1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator to flush the water lines. Do not lose the gasket in
the aerator.
□
Turn on the water supply and check for leaks. If you discover any leaks, check your connections to ensure
they are installed properly. Lift the handle to allow the water to run for at least one minute. This flushes
away any debris that could cause damage to internal parts.
□
Ensure the handle is in the off position. Use a coin to remove the aerator (B) from the faucet (A).
□
Clean the aerator (B) in the sink.
□
Reinstall the aerator (B) and housing (if applicable).
1
1
3
A
B
2
4
A
8
1 A
B
2
A
B
1