Bosch HBE5451UC Manual De Instalación página 7

Flush installation
Top View
........................................................................... I
',15_ 6"(23),5_6"(23)i
!reveal reveal!
i,,_eats cleats,:' I
(24) _- _]Z FI-'
.__ 2115,4e"____
/ (557)
I---23% (603) ---,-I
f
,, 2215_6"
(584)
flush inset
depth
()--mm
Side View
15/16"
* Flush installation requires a s/10 (5 mm) high x
21W16" (557 mm) wide x 221/16" (560 mm) deep
baseplate underneath the unit body.
2215_ 6'w-_
(584)
()=mm
Install Appliance
Electrical Installation
All model ovens on the front cover are dual rated,
designed to be connected to either 208/240V AC, 50/
60 Hz, 4 wire, single-phase power supply.
Model I Dedicated circuit required
HBE5451UC I 20 AMP
The electrical supply should be a 4-wire single-phase AC.
Install a suitable conduit box (not furnished). An
appropriately-sized, UL-listed conduit connector must be
used to correctly attach the conduit to the junction box.
NOTICE: Local Codes may vary; installation, electrical
connections and grounding must comply with all
applicable local codes.
If local codes permit grounding through the electrical
supply neutral, connect both the white neutral wire and
the bare ground wire from the oven to the white neutral
electrical supply wire.
• , CAUTION
o The appliance must be disconnected from the
power supply during all installation work.
o The appliance must only be connected with the
power cable provided.
o Protection against contact must be ensured by
the installation.
Electrical Connection
The four-wire connection is preferred, but where local
codes permit, the three wire connection is also
acceptable.
• , WARNING
When connected to a 4 or 5-wire, 120/208-Volt 3-
phase power supply; the phase C conductor is not
required for the operation of the appliance.