American Standard Mainstream 1699500.020 Manual Del Propietário página 5

1
INSTALL DRAIN PLUG AND ELL (STANDARD AND OVER-THE-RIM DRAINS)
1a. Apply putty to underside of DRAIN
PLUG [1] and drop into drain outlet.
1b. Slip RUBBER WASHER [2] on from
below and thread DRAIN PLUG [1] into
DRAIN ELL ASSEMBLY [3].
2
INSTALL OVERFLOW ASSEMBLY AND DRAIN TEE
OVER-THE-RIM DRAIN
2a. Loosen SLIP JOINT NUT & SEAL [5A]
and install onto LONG OVERFLOW
TUBE [2A]. Install LONG OVERFLOW
TUBE ASSEMBLY [2A] into the appro-
priate leg of the DRAIN TEE [6]. Apply
sealant to threads of TAILPIECE [4]
and thread into DRAIN TEE [6]. FIG.1
2b. Loosen SLIP JOINT NUT & SEAL [5B]
and install onto DRAIN ELL ASSEM-
BLY [3]. Install DRAIN ELL ASSEM-
BLY [3] into the horizontal leg of the
DRAIN TEE [6]. FIG. 2
STANARD DRAIN
2c. Loosen SLIP JOINT NUT & SEAL [5A]
and install onto SMALL OVERFLOW
TUBE [2B]. Install SMALL OVERFLOW
TUBE ASSEMBLY [2B] into the
appropriate leg of the DRAIN
TEE [6]. Apply sealant to threads of
TAIL-PIECE [4] and thread into DRAIN
TEE [6]. Install OVERFLOW GASKET [8]
to OVERFLOW TUBE ASSEMBLY [2B].
(Adjust OVERFLOW GASKET [8] to
contour of tub. FIG.1
2d. Loosen SLIP JOINT NUT & SEAL [5B]
and install onto DRAIN ELL ASSEMBLY
[3]. Install DRAIN ELL ASSEMBLY [3]
into the horizontal leg of the DRAIN
TEE [6]. FIG. 2
756031-100 Rev. 1.0 (5/23)
1
2
3
[2A]
[5A]
[6]
FIG.1
FIG.2
[4]
SEALANT
[8]
[2B]
[5A]
[6]
FIG.1
FIG.2
[4]
SEALANT
PUTTY
BATH DRAIN OUTLET
NOTE: TUB IS SHOWN CUT AWAY
FOR CLARITY OF INSTALLATION.
[5B]
[3]
NOTE: TUB IS SHOWN CUT AWAY
FOR CLARITY OF INSTALLATION.
[5B]
[3]