Bosch HMB5050 Instrucciones De Operación página 8

PowerSupply
WiringRequirements
2_
A short power-supply cord is provided to reduce the risks resulting from
becoming entangled in or tripping over a longer cord.
Longer cord sets or extension cords are available and may be used if care is
exercised in their use. Do not let cord hang over edge of a table or counter.
3. If a long cord or extension cord is used,
2_
3_
the marked electrical rating of the cord set or extension cord should be at least
as great as the electrical rating of the appliance,
the extension cord must be a grounding-type 3-wire cord, and
the longer cord should be arranged so that it will not drape over the countertop or
tabletop where it can be pulled on by children or tripped over accidentally.
The oven must be on a SEPARATE CIRCUIT. No other appliance should share
the circuit with the microwave oven. If it does, the branch circuit fuse may blow or
the circuit breaker may trip, or the food may cook slower than recommended in
this manual.
The oven must be plugged into at least a 20 AMP, 120 VOLT, 60 Hz
GROUNDED OUTLET.
Where a standard two-prong outlet is encountered, it is the personal
responsibility and obligation of the consumer to have it replaced with a properly
grounded three-prong outlet.
The VOLTAGE used must be the same as specified on this microwave oven
(120 V, 60 Hz). Using a higher voltage is dangerous and may result in a fire or
oven damage. Using a lower voltage will cause slow cooking. The dealer is not
responsible for any damages resulting from the use of the oven with any voltage
other than specified.
TV / Radio Interference
This appliance generates and uses ISM frequency energy. If not installed and used
properly, in strict accordance with the manufacturer's instructions, it may cause
interference to radio and television reception. It has been type tested and found to
comply with limits for ISM equipment persuant to part 18 of FCC rules, which are
designed to provide reasonable protection against such interference in a residential
installation. However, there is no guarantee that interference will not occur in a
particular installation. Turn the appliance on and off to determine if it causes
interference. Try the following to correct the interference:
®
®
®
®
®
Clean door and sealing surface of the oven.
Reorient the receiving antenna of the radio or television.
Relocate the microwave oven with respect to the receiver.
Move the microwave oven away from the receiver.
Plug the microwave into a different outlet so that the oven and the receiver are on
different branch circuits.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modification to this microwave oven. It is the responsibility of the user
to correct such interference.
9