Motorola Solutions IMPRES NNTN8845 Guia Del Usuario página 11

Chapter 1
Operational Safety Guidelines
• This equipment is not suitable for outdoor use. Use only in dry locations or conditions.
• Maximum ambient temperature around the charger must not exceed 40°C (104°F).
• While a radio is in a charger pocket, the radio may be on only if the radio is transmitting data
wirelessly, such as using Wi-Fi. Otherwise, turn off the radio.
• Connect the charger to an AC outlet using only a Motorola Solutions-authorized power supply.
Refer to MSI Authorized Power Supplies and Power Cords on page 23
• The equipment shall be connected to a nearby and easily accessible socket outlet.
• Make sure that the power cord is located where it will not be stepped on, tripped over, or subjected
to water, damage, or stress.
• Connect the power cord only to an appropriately fused and wired AC outlet with the correct voltage,
as specified on the product.
• Disconnect from line voltage by removing the power cord from the AC outlet.
• Connect no more than the appropriate number of chargers to a 15-A circuit or 20-A circuit, as
limited by any certified power strip being used.
NOTE: Motorola Solutions does not recommend daisy chaining power strips. Limit circuit
loading below 80% of the circuit rating.
• Use only Motorola Solutions Authorized Pockets.
1.1
Operating Instructions
The IMPRES Adaptive Charger System is a fully automated battery care system.
The charger pocket accommodates either a radio with an attached IMPRES 2 or IMPRES battery,
or an IMPRES 2 or IMPRES battery alone. Batteries charge best at room temperature. Additionally,
the charger is equipped with 2-USB Type A power outputs that facilitate the charging of two wireless
devices by a constant 2.5 W of power (5 V at 500 mA) per connector.
1.1.1
Operating Instructions
Prerequisites: Turn off the radio.
NOTE: You can only turn on the radio when the radio is transmitting data wirelessly before
charging a radio with an IMPRES 2 or IMPRES battery.
Procedure:
1 Place the radio or the IMPRES battery into the charger.
2 Remove the radio or the IMPRES battery after the radio or the IMPRE battery is fully charged.
(LED turns steady green).
MN002406A01-AL
Operational Safety Guidelines
.
11