Lenco LBT-335 Manual De Usuario página 13

be distorted due to input overload and could damage your
stereo system.
· If the Phono/Line switch is set at PHONO position but RCA jacks
connected to the stereo system's line input, the volume will be
very low due to lacking signal pre-amplification.
RCA Jack is not designed to be connected directly to the passive/unpowered
speakers and if it does, the volume will be very low.
Main Power Connection
The power adaptor is in the foam packing material. Unpack the power
adaptor and plug the small end into the DC power jack located at the back
side of the turntable. Plug the power adaptor into your power outlet.
Operation
Turntable Operation
Connect the included power adapter to unit and Press the power button
1.
(2) to power ON the turntable.
2. Remove the needle cover from the cartridge.
3. Place the slipmat on the platter and place a record on the slipmat. If
using 45 RPM records, put the 45 RPM adapter on the center spindle
before placing the record on the platter.
4. Set the 33/45 RPM Selector according to the type of record.
5. Turn the Start/Stop dial to the Start position to begin spinning the platter.
6. Unlock the arm clip and set the Lift Lever to the up position.
7. Position the tonearm over the desired location (groove) on the record.
8. Move the tonearm lift lever to the down position to move the tonearm
toward the record. Alternatively, place the needle over the desired
location on the record.
9. Carefully lower the tonearm on the record.
12