Turntable Platter and Belt Setup
1.
Install the drive belt over the inner ring under the platter and make sure
it won't fall off during the setup.
2.
Place the platter through the turntable spindle,
then rotate the platter until you see the drive
motor pulley through the window at the top
left corner.
3.
Carefully grab the drive belt and put it around
the slot of motor pulley.
4.
Connect the power adapter to the turntable and power on the turntable.
5.
Set the Motor Start/Stop switch to the Start position to see if the platter
motor spins. If the platter does not spin, try the steps listed above again.
Cartridge Down force Adjustment
The Counterweight supplied is suitable for cartridges weighing between
6.0-8.0g.
- Gently push and turn the Counterweight onto the rear of the tonearm
(with the scale facing toward the front of the turntable).
- Remove the cartridge protection cap.
- Lower the tonearm lift and position the cartridge in the space between
tonearm rest and platter.
Carefully rotate the Counterweight until the tonearm balances out. The
tonearm should return to the balanced position if it is moved up or down.
This adjustment must be done carefully.
8