Publicidad
Idiomas disponibles
Idiomas disponibles
5. Position the inlet deflector with the opening facing the left or the right side of
the filter bag. Slide the filter bag collar over the inlet deflector, matching the
notches of the bag collar to the tabs on the inlet deflector. Bag will only fit
properly one way. FIGURE 10.
6. Slide the inlet deflector with the filter bag attached into the deflector guide.
FIGURE 11.
7. Reinsert hose into inlet and tighten the locking-nut. FIGURE 12.
8. When secured in place, expand the filter bag and position around the inside
of the tank. Replace tank cover.
NOTE: When removing filter bag from tank, remove the inlet deflector from the
filter bag collar. Reinstall inlet deflector into deflector guide. Inlet deflector must
be in place for any type of cleaning.
When vacuuming fine dust, or powders of any kind (plaster, drywall dust, cold
ashes, concrete dust, etc.) a high efficiency drywall filter bag must be used.
When vacuuming normal household dust and debris, standard household
disposable filter bags may be used.
WET PICK UP OPERATION:
1. Your vacuum can be used for wet pick up. Remove ALL dirt and debris found
in the tank. Remove all dry use only filters, including the filter bag, from the
vacuum.
2. A clean cartridge filter may be used to pick up small quantities of liquid. To
use the cartridge filter; follow the cleaning and installations under dry pick up.
3. For vacuuming large quantities of liquid use a foam sleeve (not standard
with all models). A foam sleeve may be purchased at your local
CHANNELLOCK® distributor, on channellockproducts.com, or by contacting
CHANNELLOCK® customer service. To use the foam sleeve; follow the
installation instructions in this section.
4. Misting in the exhaust air or dripping of liquid around the tank cover may
occur if the filter becomes saturated during wet pick up. If this occurs, remove
the filter and allow to dry, or replace with another dry filter.
5. Turn the unit off immediately upon completing a wet pick up job or when tank
is full and ready to be emptied. When the tank is full, suction will drastically
reduce. Refer to "automatic suction shut off'' in this manual. Raise the hose
to drain any excess liquid into the tank. Follow the "emptying liquid waste"
section in this manual.
6. Before storing the vacuum cleaner or using for dry pick up, clean and dry the
interior of the tank and the underside of the tank cover. Clean and allow the
filters to dry completely. NOTE: WET PICK UP ACCESSORIES SHOULD
BE WASHED PERIODICALLY; ESPECIALLY AFTER PICKING UP WET,
STICKY KITCHEN ACCIDENTS. THIS CAN BE ACCOMPLISHED WITH A
SOLUTION OF SOAP AND WATER.
8
WARNING!
POWDERS.
FOR FINE DUST
Publicidad
