Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING AND CLEANING THE CARTRIDGE FILTER:
1. The cartridge filter can be used for dry pick up and small quantities of wet pick
up. Installation is the same for both. When picking up large quantities of water
we recommend using a foam sleeve (not standard with all models) instead
of the cartridge filter. When picking up fine dust or powders a high efficiency
filter bag (not standard with all models) must be used with the cartridge
filter.
NOTE: If cartridge filter has been used for wet pick up, it must be cleaned and
dried before using it for dry pick up.
2. With the tank cover in an upside down position, slide the cartridge filter down
over the lid cage, pushing until the filter seals against the cover. FIGURE 1.
3. Place filter retainer into the top of the cartridge filter. FIGURE 2.
4. Hold the tank cover with one hand, turn the handle on the filter retainer
clockwise to tighten, locking the filter into place. FIGURE 3.
5. To remove the filter for cleaning, again hold the tank cover and turn the filter
retainer counter-clockwise to loosen and remove. FIGURE 4.
6. Slide the cartridge filter off the lid cage. FIGURE 5.
7. To clean cartridge filter shake or brush off excess dirt. FIGURE 6.
8. Or rinse (from the inside of the filter) with water. FIGURE 7. Dry completely
(approximately 24 hours).
9. Check the filter for tears or small holes. If none are found, reinstall the filter.
To prevent damage to your vacuum, do not use a filter with a hole or a tear.
WARNING!
THE VACUUM IS LARGELY DEPENDENT ON THE FILTER. A
CLOGGED FILTER CAN CAUSE OVERHEATING AND POSSIBLY
DAMAGE THE CLEANER. CHECK THE FILTER PERIODICALLY
AND REPLACE AS REQUIRED.
INSTALLING THE DISPOSABLE FILTER BAG:
1. Use the disposable filter bag in conjunction with the cartridge filter for easy
disposal of the debris. The bag is not required for normal dry pick up. When
picking up fine dust or powders a high efficiency filter bag (not standard with
all models) must be used. NOTE: Use for dry pick up only.
2. With cord disconnected from the receptacle, pull latches in an outward motion
and remove the tank cover.
3. Unscrew hose locking-nut and remove hose from inlet. FIGURE 8.
4. Remove the inlet deflector from the deflector guide. NOTE: Hose must be
removed before the inlet deflector can be taken out. FIGURE 9.
WARNING!
FROM THE WALL OUTLET BEFORE REMOVING THE
TANK COVER.
KEEP FILTERS CLEAN. EFFICIENCY OF
WARNING!
FROM THE WALL OUTLET BEFORE REMOVING THE
TANK COVER.
ALWAYS DISCONNECT THE PLUG
ALWAYS DISCONNECT THE PLUG
7
Publicidad
